General Purpose LCD Resin is a universal resin with an even print surface and a lot of detail

This General Purpose LCD resin can be used for all types of open-source resin 3D printers (SLA, DLP and LCD/MSLA) within the range of 385 – 420 nanometers.

This resin is almost odorless, is available in many colors and has a very short curing time.

Due to the properties of accurate prints with an even and smooth print surface, this resin is used for more recreational applications, such as prototypes, figurines and models.

*NB: Pay close attention when using resins and read the safety instructions here

> Safety data sheet General Purpose LCD Resin

Features General Purpose LCD Resin:

• Accurate prints with great detail
• UV and weather resistant
• Suitable for outdoor use
• Almost odorless production
• Accurate dimensional stability
• Suitable for all types of open source Resin 3D printers

Resin properties (liquid)

• Viscosity: 500 cps at 25°C
• Density: 1.18 g/cm2

Commissioning:

• Resins consist of chemicals: When using resins, therefore, always wear protection and protective aids such as nitrin gloves, safety glasses and a mouth mask against gases and vapors type FFP2 or type A.
• Avoid contact with skin, eyes and inhalation of toxic fumes; therefore wear a suitable face mask > read the safety regulations for the use of resin carefully.
• Shake the bottle for at least 2 minutes
• Then let the bottle rest for 10 minutes to get the air bubbles away

Post-processing:

• We advise you to post-treat the 3D print to obtain the correct material properties
• Rinse your 3D print for 5 minutes in a bath of IPA or BioEthanol in an ultrasonic cleaner
• Make sure your print is completely dry for further post-processing
• The 3D print must dry for at least 30 minutes in a well-ventilated area
• Place the resin 3D print in a curing unit to cure under the influence of a UV source for about 20-30 minutes at 65°C
• A wavelength of 300-410 nanometers is preferred

Work order post-processing:

1. Remove the print
2. Clean the print with IPA or BioEthanol
3. Let the print dry well
4. Remove the support
5. Cure the print in a curing chamber under a certain temperature and UV light
6. Optional finishing (sanding, polishing, priming and painting)