Water Washable Resin "Spectrum LCD Color Mix" - 1000 ml

With Water washable Spectrum Resin you can clean your resin 3D prints with water. The resin can be mixed with 29 different color pigments.

This is a safe and environmentally friendly way of post-treatment of resin prints

This Spectrum LCD Color Resin can be used for all types of open-source resin 3D printers (SLA, DLP and LCD/MSLA) within the range of 385 – 420 nanometers.

This resin is almost odorless and the pigments are available in 29 different colors.

Due to the properties of accurate prints and huge choice of colours, this resin is used for more recreational applications, such as prototypes, figurines and models.

*NB: Pay close attention when using resins and read the safety instructions here

> Safety data sheet Water Washable Spectrum LCD Color Resin

Features Spectrum LCD Color Resin:

• Accurate prints with great detail
• Simply clean your prints with water afterwards!
• There are 29 different opaque color pigments available
• Almost odorless production
• Suitable for all types of open source Resin 3D printers

Commissioning:

• Resins consist of chemicals: When using resins, therefore, always wear protection and protective aids such as nitrin gloves, safety glasses and a mouth mask against gases and vapors type FFP2 or type A.
• Avoid contact with skin, eyes and inhalation of toxic fumes; therefore wear a suitable face mask > read the safety regulations for the use of resin carefully.
• Shake the bottle for at least 2 minutes
• Then let the bottle rest for 10 minutes to get the air bubbles away

Post-processing:

• We advise you to post-treat the 3D print to obtain the correct material properties
• Rinse your 3D print for 5 minutes in a bath of IPA or BioEthanol in an ultrasonic cleaner
• Make sure your print is completely dry for further post-processing
• The 3D print must dry for at least 30 minutes in a well-ventilated area
• Place the resin 3D print in a curing unit to cure under the influence of a UV source for about 20-30 minutes at 65°C
• A wavelength of 300-410 nanometers is preferred

Work order post-processing:

1. Remove the print
2. Clean the print with IPA or BioEthanol
3. Let the print dry well
4. Remove the support
5. Cure the print in a curing chamber under a certain temperature and UV light
6. Optional finishing (sanding, polishing, priming and painting)